FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
Wheel Speed Sensor: Service and Repair
Front Speed Sensor
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT WHEEL
3. REMOVE FRONT SPEED SENSOR
a. Disconnect the skid control sensor wire.
b. Using a 5 mm hexagon wrench, remove the bolt and the front speed sensor.
NOTE:
-
Do not attach any foreign matter to the sensor tip.
-
Ensure that no foreign matter enters the sensor installation part.
INSTALLATION
1. INSTALL FRONT SPEED SENSOR
a. Using a 5 mm hexagon wrench, install the front speed sensor with the bolt.
Torque: 8.3 N.m (85 kgf.cm, 73 in.lbf)
NOTE: Make sure that the sensor tip is clean.
b. Connect the skid control sensor wire.
2. INSTALL FRONT WHEEL
Torque: 112 N.m (1,137 kgf.cm, 82 ft.lbf)
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)
4. CHECK VSC SENSOR SIGNAL