FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
Yaw Rate Sensor: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE PARKING BRAKE HOLE COVER SUBASSEMBLY
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)
5. REMOVE CONSOLE UPPER REAR PANEL SUBASSEMBLY
6. REMOVE YAW RATE AND DECELERATION SENSOR
a. Disconnect the yaw rate and deceleration sensor connector.
b. Remove the 2 bolts and remove the yaw rate and deceleration sensor.
INSTALLATION
1. INSTALL YAW RATE AND DECELERATION SENSOR
a. Install the yaw rate and deceleration sensor with the 2 bolts.