FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
Brake Pedal Assy: Testing and Inspection
BRAKE PEDAL
ON-VEHICLE INSPECTION
1. INSPECT AND ADJUST BRAKE PEDAL
(a)
Inspect the brake pedal height.
Pedal height from dash panel: 168.7 to 178.7 mm (6.642 to 7.035 in.)
If the pedal height is incorrect, adjust the rod operating adapter length.
(b) Adjust the brake pedal height.
(1) Disconnect the connector from the stop light switch.
(2) Turn the stop light switch counterclockwise, and remove the stop light switch.
(3) Remove the hydraulic brake booster.
(4) Loosen the clevis lock nut.
(5) Adjust the rod operating adapter length by turning the pedal push rod clevis.
Rod operating adapter length A: 201.7 to 202.7 mm (7.941 to 7.980 in.)
(6) Tighten the clevis lock nut.
Torque: 26 N*m (260 kgf*cm, 19 ft.*lbf.)
(7) Install the hydraulic brake booster.