FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
9. REMOVE MASTER CYLINDER PUSH ROD CLEVIS
(a)
Loosen the lock nut on the rod operating adapter, and then remove the push rod clevis and lock nut.
(b) Loosen the lock nut on the brake master cylinder side, and then remove the rod operating adapter and lock nut.
10. REMOVE MASTER CYLINDER BOOT
11. REMOVE PISTON
(a)
When pressing in the piston with a screwdriver, use a pin or the equivalent to push the C-ring from the hole in the master cylinder body. Then
remove the C-ring with another screwdriver.
(b) Remove the piston by pulling it straight out, not at an angle.
NOTICE: If the piston is pulled out at an angle, there is a possibility that the cylinder bore could be damaged.
12. REMOVE BRAKE BOOSTER ACCUMULATOR ASSEMBLY
(a)
Place the brake booster with accumulator pump assembly in a vise lined with a cloth.
(b) Remove the brake booster accumulator.