FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
11. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
(a)
Apply lithium soap base glycol grease to 3 new grommets.
(b) Install the 3 grommets onto the master cylinder body.
NOTICE: The grommets are different sizes. Install the grommets in their correct positions.
(c)
Install the master cylinder reservoir with the screw.
Torque: 1.7 N*m (17 kgf*cm, 15 in.*lbf.)
(d) Using a pin punch and hammer, install a new pin onto the master cylinder reservoir.
12. INSTALL BRAKE ACTUATOR NO. 1 BRACKET
(a)
Install the fluid level warning switch connector.
(b) Using a 5 mm hexagon wrench, install the brake actuator bracket with the bolt.