FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
(c)
Check the valve lift.
Valve lift: 8.0 mm (0.31 in.) or more at 95°C (203°F)
If the valve lift is not as specified, replace the thermostat.
(d) Check that the valve is fully closed when the thermostat is at low temperatures (below 77°C (171°F)).
If not fully closed, replace the thermostat.
INSTALLATION
1. INSTALL WATER INLET WITH THERMOSTAT
(a)
Install a new gasket onto the water inlet with thermostat.
(b) Install the water inlet with thermostat with the 3 nuts.
Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf.)
2. CONNECT NO. 2 RADIATOR HOSE
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf.)
4. ADD ENGINE COOLANT
5. CHECK FOR ENGINE COOLANT LEAKAGE
6. INSTALL V-BANK COVER