FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
/Page-1247004.png)
1. INSTALL NO. 1 COOLER THERMISTOR
a. Install the sensor onto the evaporator as shown in the illustration.
b. Check that the sensor sticks to the evaporator surface as shown in the illustration (A: Sensor, B: Evaporator).
NOTE: If reusing the evaporator, do not reinsert the sensor in the same position that it was in before. Insert it within area C shown in the
illustration.
2. INSTALL NO. 1 COOLER EVAPORATOR SUBASSEMBLY
a. Apply sufficient compressor oil (ND-OIL8) to 2 new O-rings and the fitting surface of the cooler evaporator.
Compressor oil: ND-OIL8 or the equivalent
b. Install the 2 O-rings onto the cooler evaporator.
c. Install the cooler evaporator.
HINT: If a new cooler evaporator is installed, add compressor oil to the cooler evaporator as given.
Compressor oil: ND-OIL8 or the equivalent.
Add 40 cc (1.35 fl. oz.)
d. Install the cooler evaporator onto the heater case.