FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
/Page-1656001.png)
Turn Signal Flasher: Testing and Inspection
TURN SIGNAL FLASHER ASSEMBLY
ON-VEHICLE INSPECTION
1. INSPECT TURN SIGNAL FLASHER CIRCUIT
a. Check the power source circuit and ground circuit.
1. Disconnect the turn signal flasher connector.
2. Measure the voltage and check the results in accordance with the value(s) in the table given.
If the result is not as specified, there may be a malfunction on the wire harness side.
3. Measure the resistance and check the result in accordance with the value(s) in the table given.
If the result is not as specified, there may be a malfunction on the wire harness side.
b. Check the output operation signal.
1. Reconnect the turn signal flasher connector.