FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
f.
Install SST and the fuel tube connector onto the vehicle.
g. Wipe off any spilt gasoline.
h. Connect the cable to the negative battery terminal.
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)
i.
Connect the intelligent tester to the DLC3.
j.
Turn the ignition switch ON.
k. Turn the intelligent tester ON.
l.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST / FUEL PUMP / SPD / ON.
m. Measure the fuel pressure.
Standard: 281 to 287 kPa (2.87 to 2.93 kgf/sq.cm, 40.8 to 41.7 psi)
-
If the fuel pressure is greater than the standard value, replace the fuel pump.
-
If the fuel pressure is less than the standard value, check the connection between the fuel hose and fuel pump.
n. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST / PRIMARY / FUEL PUMP / SPD / OFF.
o. Check that the fuel pressure does not change for 5 minutes.
Standard: 147 kPa (1.5 kgf/sq.cm, 21 psi)