FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
(3) Pull out the wire harness shown in the illustration.
(4) Connect the tester probe of a timing light to the wire of the ignition coil connector for the No. 1 cylinder.
NOTICE:
^ Use timing light that detects the first signal.
^ After checking, wrap the wire harness with tape.
(5) Inspect the ignition timing during idling.
Ignition timing: 8 to 12°CA BTDC during idling (Transmission in neutral position)
(6) Remove SST from the DLC3.
(7) Inspect the ignition timing during idling.
Ignition timing: 7 to 24°CA BTDC during idling (Transmission in neutral position)
(8) Install the air cleaner.