FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
![background image](/toyota/fj_cruiser_4wd/v6-4.0l_(1gr-fe)/Page-1311012.png)
4. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
5. REMOVE REAR SEAT SHOULDER BELT COVER
6. REMOVE REAR SEATBACK LOCK COVER
7. REMOVE REAR SEAT HEADREST SUPPORT
8. REMOVE REAR SEATBACK LOCK RELEASE BUTTON
9. REMOVE REAR SEATBACK STOP BUTTON GROMMET
10. REMOVE REAR SEATBACK FRAME SUBASSEMBLY
11. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY
a. Remove the nut and the rear center seat outer belt.
INSTALLATION
1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY
a. Hook the stay of the retractor onto the 2 rear seatback frame hooks and install the retractor with the nut.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
b. Check that the ELR locks.
NOTE: Perform the check with the front seat outer belt installed.
1. With the belt installed, check that the belt locks when it pulled out quickly.
If the operation is not as specified, replace the rear seat outer belt.
2. INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY
3. INSTALL REAR SEATBACK STOP BUTTON GROMMET
4. INSTALL REAR SEATBACK LOCK RELEASE BUTTON
5. INSTALL REAR SEAT HEADREST SUPPORT
6. INSTALL REAR SEATBACK LOCK COVER
7. INSTALL REAR SEAT SHOULDER BELT COVER
8. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
9. INSTALL REAR SEAT HEADREST ASSEMBLY
10. INSTALL REAR SEATBACK ASSEMBLY
11. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY
Rear Seat Inner Belt Assembly