FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
/Page-1315002.png)
4. REMOVE INTEGRATION CONTROL PANEL ASSEMBLY (Built-in Front Passenger Seat Belt Warning Light)
a. Remove the 2 screws.
b. Disengage the 4 clips and remove the front passenger seat belt warning light.
c. Disconnect the 2 air conditioner amplifier connectors and the blower switch connector.
INSTALLATION
1. INSTALL INTEGRATION CONTROL PANEL ASSEMBLY (Built-in Front Passenger Seat Belt Warning Light)
a. Connect the blower switch connector and the 2 air conditioner amplifier connectors.
b. Engage the 4 clips and install the front passenger seat belt warning light.
c. Tighten the 2 screws.
2. INSTALL INSTRUMENT PANEL GARNISH RH
3. INSTALL INSTRUMENT PANEL GARNISH LH
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)