FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
3. REMOVE ULTRASONIC SENSOR
a. Disconnect the ultrasonic sensor connector.
b. Remove the retainer and the ultrasonic sensor as shown in the illustration.
INSTALLATION
HINT: The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. INSTALL ULTRASONIC SENSOR
a. Install the ultrasonic sensor with the retainer as shown in the illustration.
b. Connect the ultrasonic sensor connector.
2. INSTALL REAR BUMPER COVER
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)