FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
a. Install the 2 screws.
Torque: 1.8 N.m (18 kgf.cm, 16 in.lbf)
5. INSTALL TERMINAL INSULATOR
6. INSTALL GENERATOR REAR END COVER
a. Install the rear end cover with the 3 nuts.
Torque: 4.6 N.m (47 kgf.cm, 41 in.lbf)
7. INSTALL GENERATOR PULLEY
SST 09820-63010 (09820-06010, 09820-06020)
a. Install the pulley onto the rotor shaft by tightening the pulley nut by hand.
b. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise with the specified torque.
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
NOTE: Check that SST is secured to the rotor shaft.
c. Mount SST 2 in a vice.
d. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.