FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
![background image](/toyota/fj_cruiser_4wd/v6-4.0l_(1gr-fe)/Page-1174004.png)
1. INSTALL FRONT SUSPENSION UPPER ARM BUSH
(a)
Using SST and a press, install a new upper arm bush (front side).
SST 09710-26010 (09710-05061)
(b) The installation procedure for the rear side is the same as that for the front side.
INSTALLATION
1. TEMPORARILY TIGHTEN FRONT UPPER SUSPENSION ARM
(a)
Install the upper arm and temporarily tighten the bolt, 2 washers and nut.
(b) Install the bracket with the bolt.
Torque: 5.8 N*m (59 kgf*cm, 51 in.*lbf)
(c)
Install a new nut and a new clip.
Torque: 110 N*m (1,122 kgf*cm, 81 ft.*lbf)
2. INSTALL SKID CONTROL SENSOR WIRE