FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
(c)
Provisionally tighten the bolt, nut and washer as shown in the illustration.
2. INSTALL TIE ROD END SUB-ASSEMBLY
3. INSTALL FRONT STABILIZER BAR
4. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a)
Install the stabilizer link onto the steering knuckle with the nut.
Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf)
HINT: If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
5. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: The installation procedure for the RH side is the same as that for the LH side.
6. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
7. INSTALL FRONT WHEELS
Torque: 112 N*m (1,137 kgf*cm, 82 ft.*lbf)
8. STABILIZE SUSPENSION
(a)
Jack down the vehicle.
(b) Bounce the vehicle up and down several times to stabilize the suspension.
9. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
(a)
Fully tighten the nut.
Torque: 135 N*m (1,377 kgf*cm, 100 ft.*lbf)
10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
DISPOSAL