FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
Torque: 47 N*m (479 kgf*cm, 35 ft.*lbf)
5. INSTALL RELEASE BEARING HUB CLIP
6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY
(a)
Apply release hub grease to the release fork and release bearing assembly contact surfaces, release fork and push rod contact surface and
release fork pivot point.
Sealant: Toyota Genuine Release Hub Grease or Equivalent
(b) Install the release fork onto the release bearing assembly.
7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY
(a)
Apply clutch spline grease to the input shaft spline.
Sealant: Toyota Genuine Clutch Spline Grease or Equivalent
NOTICE: Do not apply grease to portion A shown in the illustration.
(b) Install the bearing onto the release fork, and then install them onto the transaxle assembly.
NOTICE: After installation, move the fork forward and backward to check that the release bearing slides smoothly.
8. INSTALL MANUAL TRANSMISSION ASSEMBLY