Highlander 2WD V6-3.0L (1MZ-FE) (2003)
a. Check the voltage or continuity of each terminal of the wire harness side connectors.
NOTE:
-
The check should be started from the backside of the ECM with the ECM connector being connected.
-
Inspect the power source voltage (ignition switch ON: 10 - 14 V) and body ground (ignition switch OFF: below 5 (each ground terminal
<-> engine ground, body ground)) before the check.
HINT: If a "waveform" is specified in the table, the actual waveform.