Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
_hybrid/Page-1468015.png)
(a) Disengage the 3 claws and remove the visor bracket cover.
HINT: Tape the screwdriver tip before use.
(b) Remove the 2 screws and vizor assembly.
(c) Disconnect the connector.
64. REMOVE RH VISOR ASSEMBLY
65. REMOVE VISOR HOLDER
(a) Remove the visor holder by turning it counterclockwise.
HINT: Use the same procedure to remove the other side.
66. REMOVE ROOF HEADLINING ASSEMBLY
(a) Disconnect the roof wire connector and disengage the clamps from the front pillar LH.
(b) Disconnect the washer hose. Remove the bolt and disconnect the radio antenna cord connector and disengage the clamps from the front pillar
RH.
(c) Disconnect the washer hose. Disconnect the radio antenna cord connector and disengage the clamps from the rear quarter pillar RH.
(d) Disconnect the sliding roof drive gear connector.(w/ sliding roof)
(e) Remove the sunroof opening trim moulding. (w/ sliding roof)
(f) Remove the 4 clips.
(g) Remove the roof headlining from the vehicle through the back door side.
67. REMOVE ROOF WIRE AND RADIO ANTENNA CORD