Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
_hybrid/Page-821001.png)
Fuel Gauge Sender: Testing and Inspection
FUEL SENDER GAUGE ASSEMBLY
INSPECTION
1. INSPECT FUEL SENDER GAUGE ASSEMBLY
a. Check that the float moves smoothly between F and E.
b. Disconnect the fuel sender gauge connector.
c. Remove the fuel sender gauge assembly.
d. Measure the resistance between terminals 2 (FE) and 3 (FS) of the connector according to the value(s) in the table.
HINT: If the value is not as specified, replace the fuel sender gauge assembly.