toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 6440 > < Initial Inspection and Diagnostic Overview|Page 6438
Page 2
background image

HINT:
-

The passenger airbag ON/OFF indicator comes on based on the timing chart in order to check the indicator light circuit.

-

When the occupant classification system has trouble, both the SRS warning light and the passenger airbag ON/OFF indicator ("OFF")
come on. In this case, check the DTCs in the "AIRBAG SYSTEM" first.

Symptom Simulation

SYMPTOM SIMULATION

HINT:  The most difficult case in troubleshooting is when no symptoms occur. In such cases, a thorough customer problem analysis must be carried out.
Then the same or similar conditions and environment in which the problem occurred in the customer's vehicle should be simulated. No matter how
experienced or skilled a technician may be, if he proceeds to troubleshoot without confirming the problem symptoms, he will likely overlook something
important and make a wrong guess at some points in the repair operation.

This leads to a standstill in troubleshooting.

a. Vibration method: When vibration seems to be the major cause.

HINT:  Perform the simulation method only during the primary check period (for approximately 6 seconds after the ignition switch is turned to
the ON position). 

Initial Inspection and Diagnostic Overview|Page 6440 > < Initial Inspection and Diagnostic Overview|Page 6438