Highlander 2WD V6-3.5L (2GR-FE) (2008)
(e) Protect the curtain shield airbag assembly.
(1) Cover the airbag with a 700 mm (27.56 in.) x 120 mm (4.72 in.) cloth or piece of nylon and fix the ends of the cover with tape, as shown in
the illustration.
NOTE: Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.
20. REMOVE REAR DOOR SCUFF PLATE LH
(a) Disengage the 5 claws, 3 clips and guide, and remove the rear door scuff plate LH.
21. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
(a) Remove the rear door opening trim weatherstrip LH.
22. REMOVE LOWER CENTER PILLAR GARNISH LH
(a) Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.
23. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front
Seat Outer Belt Assembly/Removal
24. REMOVE CENTER PILLAR GARNISH LH