Highlander 2WD V6-3.5L (2GR-FE) (2008)
ENGINE HOOD / DOOR: POWER BACK DOOR MAIN SWITCH: REMOVAL
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE RH
(a) Disengage the 8 claws and guide, and remove the front door scuff plate RH.
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
(a) Remove the clip.
(b) Disengage the clip and claw, and remove the cowl side trim sub-assembly RH.
3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
4. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
5. REMOVE BACK DOOR CONTROL SWITCH
(a) Disengage the 2 claws and remove the back door control switch.
Installation
ENGINE HOOD / DOOR: POWER BACK DOOR MAIN SWITCH: INSTALLATION
INSTALLATION
1. INSTALL BACK DOOR CONTROL SWITCH
(a) Engage the 2 claws and install the back door control switch.
2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation