Highlander 2WD V6-3.5L (2GR-FE) (2008)
B. Install the oil pan with the 16 bolts and 2 nuts.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
20. Install the cylinder head cover sub-assembly (for bank 1).
A. Apply seal packing as shown.
Seal packing: Toyota Genuine Seal Packing Black, Three Bond 1207B, or equivalent
NOTE:
-
Remove any oil from the contact surface.
-
Install the head cover within 3 minutes after applying seal packing.
-
Do NOT start the engine for at LEAST 2 hours after installing.
B. Install 3 NEW gaskets as shown.
C. Install a NEW gasket to the head cover.