Highlander 2WD V6-3.5L (2GR-FE) (2008)
(c) Install the rear airbag sensor with the bolt and pin.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTE:
-
If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a
new one.
-
When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between
other parts.
-
Make sure that the pin is securely inserted into the body hole.
-
Tighten the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.
(d) Check that there are no loose parts after installing the rear airbag sensor.
(e) Connect the connector to the rear airbag sensor.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
4. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY See: Seat Belt Systems/Seat Belt/Service and Repair/Rear No. 1 Seat Outer Belt
Assembly/Installation
5. INSTALL FRONT DECK SIDE TRIM COVER See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
6. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Installation
7. INSTALL NO. 2 DECK SIDE TRIM HOOK (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
8. INSTALL ROPE HOOK ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
9. INSTALL REAR DECK TRIM COVER (for LH Side without Remote Folding Function) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Installation
10. INSTALL RECLINING REMOTE CONTROL BEZEL (for LH Side with Remote Folding Function) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Installation
11. INSTALL REAR POWER OUTLET SOCKET COVER (for LH Side) See: Power and Ground Distribution/Auxiliary Power Outlet/Service and
Repair/Rear Power Outlet Socket/Installation
12. INSTALL REAR POWER POINT SOCKET ASSEMBLY (for LH Side) See: Power and Ground Distribution/Auxiliary Power Outlet/Service
and Repair/Rear Power Outlet Socket/Installation
13. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH (for RH Side) See: Body and Frame/Interior Moulding /