Highlander 2WD V6-3.5L (2GR-FE) (2008)
(d) Reconnect the park/neutral position switch connector.
C -- REPLACE PARK/NEUTRAL POSITION SWITCH
B -- REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
A -- Continue to next step.
12. CHECK HARNESS AND CONNECTOR (ECM - PARK/NEUTRAL POSITION SWITCH)
(a) Disconnect the ECM connector.
(b) Disconnect the park/neutral position switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance (check for open):
Standard resistance (check for short):
(d) Reconnect the ECM connector.
(e) Reconnect the park/neutral position switch connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - PARK/NEUTRAL POSITION SWITCH)
OK -- Continue to next step.
13. INSPECT RELAY (ST CUT RELAY)
(a) Remove the ST CUT relay from the engine room relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance: