Highlander 4WD L4-2.4L (2AZ-FE) (2001)
/Page-361012.png)
a. Install the bolt and crankshaft position sensor.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
b. Confirm the wire harness of the crank position sensor is placed as shown in the illustration.
47. INSTALL CRANKSHAFT PULLEY [13471 / 98-13]
a. Align the pulley set key with the key groove of the pulley, and side on the pulley.
b. Using SST, install the pulley bolt.
SST 09213-54015 (91651-60855), 09330-00021
Torque: 170 Nm (1733 kgf-cm, 125 inch lbs.)
c. Turn the crankshaft counterclockwise, and disconnect the plunger knock pin from the hook.
d. Turn the crankshaft clockwise, and check that the slipper is pushed by the plunger.
48. INSTALL CYLINDER HEAD COVER SUB-ASSY [11201 / 98-5]
49. INSTALL IGNITION COIL ASSY [19500 / 98-34]
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
50. INSTALL VANE PUMP ASSY [44320 / 98-73]
51. INSTALL GENERATOR ASSY [27020 / 98-35]
52. INSTALL FAN AND GENERATOR V BELT [16361A / 98-25]
53. INSTALL ENGINE MOUNTING BRACKET NO.2 RH [12316 / 98-10]
Torque: 52 Nm (531 kgf-cm, 38 ft. lbs.)
54. INSTALL ENGINE MOVING CONTROL ROD W/BRACKET