Highlander 4WD L4-2.4L (2AZ-FE) (2001)
16.
INSTALL REAR AXLE SHAFT RH OIL SEAL. Using the SST below, and a press, install the new oil seal (inner side) to the rear axle carrier.
^
SST 09608-10010
17.
INSTALL AXLE ASSEMBLY RR RH. Install the rear axle to the shock absorber with the 2 bolts and nuts.
Torque: 255 N.m (2,600 kgf.cm, 188 ft.lbf
NOTE:
Insert the bolt from the rear side of the vehicle and install the nut.
18.
CONNECT PARKING BRAKE CABLE ASSEMBLY NO. 3 (see page 33-17).
19.
APPLY HIGH TEMPERATURE GREASE (see page 33-17).
20.
INSTALL PARKING BRAKE SHOE (see page 33-17).
21.
INSTALL PARKING BRAKE SHOE STRUT RH (see page 33-17).
22.
INSTALL PARKING BRAKE SHOE STRUT COMPRESSION SPRING (see page 33-17).
23.
INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING (see page 33-17).
24.
CHECK PARKING BRAKE INSTALLATION (see page 33-17).
25.
INSTALL REAR DISC.
26.
ADJUST PARKING BRAKE SHOE CLEARANCE (see page 33-17).
27.
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY RH.
A.
Install the brake calliper with the 2 bolts.
Torque: 58 N.m (592 kgf.cm, 43 ft.lbf)
B.
Install the flexible hose and speed sensor wire harness with the bolt.
Torque: 19 N.m (194 kgf.cm, 14 ft.lbf)