Highlander 4WD V6-3.0L (1MZ-FE) (2003)
![background image](/toyota/highlander_4wd/v6-3.0l_(1mz-fe)/Page-1191001.png)
Headliner: Service and Repair
REPLACEMENT
HINT:
-
The installation is in the reverse order of the removal. However, when there is a special point concerning the installation, it is indicated.
-
On the RH side, use the same procedures as on the LH side.
1. REMOVE REAR SEAT ASSEMBLY RH
2. REMOVE REAR SEAT ASSEMBLY LH
3. REMOVE FRONT DOOR SCUFF PLATE RH
a. Using a screwdriver, remove the front door scuff plate.
HINT: Tape the screwdriver tip before use.
4. REMOVE FRONT DOOR SCUFF PLATE LH
5. REMOVE REAR DOOR SCUFF PLATE RH
a. Using a screwdriver, remove the rear door scuff plate.
HINT: Tape the screwdriver tip before use.
6. REMOVE REAR DOOR SCUFF PLATE LH
7. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
8. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
9. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
10. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
11. REMOVE BACK DOOR WEATHERSTRIP
12. REMOVE CENTER PILLAR GARNISH LOWER RH