Highlander 4WD V6-3.0L (1MZ-FE) (2003)
/Page-303006.png)
d. Install the 5 bearing caps in their proper locations.
e. Apply a light coat of engine oil on the threads and under the heads of the bearing cap bolts.
f.
Install and uniformly tighten the 10 bearing cap bolts, in several passes, in the sequence shown.
Torque: 16 Nm (163 kgf-cm,12 ft. lbs.)
g. Remove the service bolt.
32. INSTALL TIMING BELT NO.3 COVER
33. INSTALL CAMSHAFT TIMING PULLEY
SST 09960-10010 (09962-0100O, 09963-01000), 09249-63010
34. INSTALL TIMING BELT IDLER SUB-ASSY NO.2
Torque: 43 Nm (438 kgf-cm, 32 ft. lbs.)
35. INSPECT TIMING BELT
36. INSTALL TIMING BELT
SST 09960-10010 (09962-0100O, 09963-01000)
37. INSTALL CHAIN TENSIONER ASSY NO.1
38. INSTALL TIMING BELT GUIDE NO.2
39. INSTALL TRANSVERSE ENGINE ENGINE MOUNTING BRACKET
40. INSTALL TIMING BELT NO.2 COVER
41. INSTALL TIMING BELT NO.1 COVER
42. INSTALL CRANKSHAFT PULLEY
SST 09213-54015 (91651 -60855), 09330-00021
43. INSTALL GENERATOR BRACKET NO.2
Torque: 28 Nm (286 kgf-cm, 21 ft. lbs.)
44. INSTALL ENGINE MOUNTING STAY NO.2 RH
45. INSTALL ENGINE MOVING CONTROL ROD
46. INSPECT VALVE CLEARANCE
47. ADJUST VALVE CLEARANCE
SST 09248-55040 (09248 05410, 09248-05420)
48. INSTALL VANE PUMP V BELT
49. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
50. INSPECT DRIVE BELT DEFLECTION AND TENSION (REFERENCE)
51. INSTALL CYLINDER HEAD COVER SUB-ASSY LH
52. INSTALL IGNITION COIL ASSY
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
53. INSTALL V-BANK COVER
54. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
55. ADD COOLANT
56. INSPECT FOR ENGINE COOLANT LEAKS