Highlander 4WD V6-3.0L (1MZ-FE) (2003)
/Page-304006.png)
c. Apply MP grease to a new oil seal lip.
d. Install the oil seal to the camshaft.
NOTICE:
-
Do not turn over the oil seal lip.
-
Insert the oil seal until it stops.
e. Remove any old packing material from the contact surface.
f.
Apply seal packing to the No. 1 bearing cap as shown. Seal packing: Part No. 0882-00080 or equivalent
NOTICE:
-
Install the No. 1 bearing cap within 5 minutes after applying seal packing.
-
Do not put into engine oil within 2 hours after installing.
g. Install the 5 bearing caps in their proper locations.
h. Apply a light coat of engine oil on the threads and under the heads of the bearing cap bolts.
