Highlander 4WD V6-3.0L (1MZ-FE) (2003)
13. CENTER SPIRAL CABLE
a. Check that the ignition switch is OFF
b. Check that the battery negative terminal is disconnected.
NOTE: Do not start the operation for 90 seconds after removing the terminal.
c. Turn the cable counterclockwise by hand until it becomes harder to turn.
HINT: The cable will rotate about 2.5 turns to either left or right of the center.
d. Then rotate the cable clockwise about 2.5 turns to align the marks.
14. INSTALL STEERING WHEEL ASSY
Torque: 35 N-m (360 kgf.cm, 26 ft.lbf)
15. INSPECT STEERING WHEEL CENTER POINT
16. INSTALL HORN BUTTON ASSY
17. INSPECT HORN BUTTON ASSY
18. INSPECT SRS WARNING LIGHT