Highlander 4WD V6-3.0L (1MZ-FE) (2003)
/Page-956002.png)
11. REMOVE VANE PUMP PULLEY
a. Using SST, stop the pulley rotation and loosen the nut.
SST 09960-10010 (09962-01000, 09963-01000)
b. Remove the nut and vane pump pulley from the vane pump shaft.
12. REMOVE PRESSURE PORT UNION
a. Remove the pressure port union.
b. Remove the O-ring from the pressure port union.
13. REMOVE FLOW CONTROL VALVE
14. REMOVE FLOW CONTROL VALVE COMPRESSION SPRING
15. REMOVE PUMP BRACKET FRONT
a. Remove the 3 bolts, pump bracket front and pump bracket rear from the vane pump assy.
16. REMOVE VANE PUMP HOUSING REAR
a. Remove the 4 bolts and pump housing rear from the pump housing front.
b. Remove the gasket.
c. Remove the 2 O-rings from the pump housing rear.
17. REMOVE VANE PUMP SIDE PLATE REAR
a. Remove the wave washer from the side plate rear.
b. Remove the side plate rear.
18. REMOVE VANE PUMP CAM RING
19. REMOVE VANE PUMP ROTOR
a. Remove the 10 vane plates from the vane pump rotor.
b. Using a screwdriver, remove the shaft snap ring from the vane pump shaft.
c. Remove the vane pump rotor.
20. REMOVE VANE PUMP SHAFT
21. REMOVE VANE PUMP HOUSING OIL SEAL
a. Using a screwdriver with vinyl tape wound around its tip, remove the oil seal.
NOTICE: Be careful not to damage the pump housing.
