Highlander 4WD V6-3.0L (1MZ-FE) (2003)
21. INSTALL REAR SUSPENSION ARM ASSY NO.1 LH
a. Install the rear suspension arm No. 1 (out side) to the rear axle carrier with the bolt and nut.
Torque: 177 Nm (1,800 kgf-cm, 131 ft. lbs.)
HINT: Insert the bolt from the front side of the vehicle and temporally install the bolt.
22. INSTALL REAR SUSPENSION ARM ASSY NO.1 RH
23. INSTALL REAR SUSPENSION ARM ASSY NO.2 LH
a. Install the rear suspension arm No. 2 (out side) to the rear axle carrier with the bolt and nut.
Torque: 177 Nm (1,800 kgf-cm, 131 ft. lbs.)
24. INSTALL REAR SUSPENSION ARM ASSY NO.2 RH
25. TEMPORARY TIGHTEN STRUT ROD ASSY REAR
26. STABILIZE SUSPENSION
27. FULLY TIGHTEN STRUT ROD ASSY REAR
28. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
29. TEMPORARY TIGHTEN PROPELLER W/CENTER BEARING SHAFT ASSY
30. FULLY TIGHTEN PROPELLER W/CENTER BEARING SHAFT ASSY
31. INSTALL EXHAUST PIPE ASSEMBLY
32. CHECK EXHAUST GAS LEAK
33. INSPECT REAR WHEEL ALIGNMENT
34. CHECK ABS SPEED SENSOR SIGNAL
Rear Suspension Arm ASSY No.2 LH, Replacement
REPLACEMENT
HINT: This procedure is provided for the replace on the LH side. Replace the other side in the same way.
1. REMOVE REAR WHEEL
2. REMOVE REAR SUSPENSION ARM ASSY NO.2 LH (2WD)
a. Remove the bolt and disconnect the rear suspension arm No. 2 (inner side).