Highlander 4WD V6-3.0L (1MZ-FE) (2003)
/Page-701009.png)
16. INSTALL OUTBOARD JOINT END COVER
a. Using SST and a press, install the end cover.
SST 09223-15020, 09950-70010 (09951-07150)
17. INSTALL REAR WHEEL BEARING DUST DEFLECTOR NO.1 LH
a. Using SST and a press, install a new No. 1 dust deflector.
SST 09309-36010, 09316-20011
NOTICE: Be careful not to damage the ABS speed sensor rotor.
18. INSTALL REAR DRIVE SHAFT OUTBOARD JOINT BOOT
HINT: Before installing the boots, wrap the spline of the outboard joint shaft with vinyl tape to prevent the boots from being damaged.
a. Install the outboard joint boot, 2 outboard joint boot clamps, 2 inboard joint boot clamps and inboard joint boot.
b. Before assembling the boots, pack the outboard joint and boot with grease in the boot kit.
Grease capacity: 107 - 117 g (3.77 - 4.13 oz.)
c. Make sure that the 2 boots are on the shaft groove.
19. INSTALL REAR DRIVE SHAFT OUTBOARD JOINT BOOT NO. 2 CLAMP
a. Using a screwdriver, install the outboard joint boot clamp.