Highlander 4WD V6-3.3L (3MZ-FE) (2004)
c. Install the 2 bolts and 2 nuts to the lower side of front shock absorber with coil spring.
Torque: 230 Nm (2,350 kgf-cm, 170 ft-lbf)
HINT: When installing the nuts, keep the bolts from rotating and torque the nut.
d. Install the flexible hose and ABS speed sensor wire harness bracket with the bolt.
Torque: 18.8 Nm (192 kgf-cm, 14 ft. lbs.)
e. Fully tighten the lock nut.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
9. INSTALL FRONT STABILIZER LINK ASSY LH
a. Install the stabilizer bar link with the nut.
Torque: 74 Nm (755 kgf-cm, 55 ft. lbs.)
HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
10. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
DISPOSAL
HINT: Dispose the RH side by the same procedures with the LH side.