Highlander 4WD V6-3.3L (3MZ-FE) (2004)
(e) Using SST, measure the clearance of the outboard joint boot LH clamp. SST 09240-00020 Clearance: 1.3 mm (0.051 in.) or less
NOTICE: When the measured value is greater than the specified value, retighten the clamp.
23. INSTALL REAR DRIVE SHAFT OUTBOARD JOINT BOOT LH NO.2 CLAMP
(a) Place SST onto the outboard joint boot LH No.2 clamp. SST 09521-24010
(b) Tighten the SST so that the outboard joint boot LH No.2 clamp is pinched.
NOTICE: Do not overtighten the SST.
(c) Using SST, measure the clearance of the outboard joint boot LH No.2 clamp. SST 0924O~00020
Clearance: 1.3 mm (0.051 in.) or less
NOTICE: When the measured value is greater than the specified value, retighten the clamp.
24. INSTALL REAR DRIVE SHAFT INBOARD JOINT ASSY LH
(a) Place the beveled side of the tripod joint axial spline toward the outboard joint shaft.