Highlander 4WD V6-3.5L (2GR-FE) (2008)
/Page-771002.png)
(1) Press a piece of paper towel against the drain plug or deposits on the lip of the drain plug and check that the paper towel is not wet.
If the paper towel is wet, replace the water pump assembly.
If the paper towel is not wet, thoroughly clean the area around the water pump.
(e) Install the water pump pulley
2. INSPECT WATER PUMP ASSEMBLY
(a) Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the water pump assembly.
(b) Install the fan and generator V belt
