Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
A.
Remove the Circuit Opening Relay from Relay Block No. 1 located to the left of the Instrument Panel Junction Block behind the left lower
finish panel.
B.
Start the engine. After the engine has stalled, turn the ignition switch OFF.
C.
Reinstall the Circuit Opening Relay.
D.
Disconnect the negative (-) battery cable.
2.
Disconnect Fuel Pipe Sub-assembly No. 1.
NOTE:
^
Ensure that the removed bolt and washers are discarded.
^
Refer to the "Component Identification" section to ensure that the correct bolt and washers are removed and damper is installed.