Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
28. INSTALL VANE PUMP SHAFT
a. Coat inside bushing surface of the pump housing front with power steering fluid.
b. Gradually insert the vane pump shaft from the pulley side.
NOTICE: Do not damage the oil seal lip in the pump housing.
29. INSTALL VANE PUMP ROTOR
a. Install the vane pump rotor.
b. Using a snap ring expander, install a new snap ring to the vane pump shaft.
30. INSTALL VANE PUMP CAM RING
a. Align the holes of the cam ring with 2 straight pins, and install the cam ring with inscribed mark facing outward.
b. Coat 10 vane plates with power steering fluid.
c. Install the vane plates with the round end facing outward.
d. Install a new gasket.