Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
/Page-888015.png)
-
The steering wheel pad is very hot when the airbag is deployed, so leave it alone for at least 30 minutes after deployment.
-
Use gloves and safety glasses when handling a steering wheel pad with the deployed airbag.
-
Always wash your hands with water after completing the operation.
-
Do not apply water, etc.to a steering wheel pad with the deployed airbag.
CAUTION:
-
The steering wheel pad is very hot when the airbag is deployed, so leave it alone for at least 30 minutes after deployment.
-
When moving a vehicle for scrapping which has a steering wheel pad with the deployed airbag, use gloves and safety glasses.
-
Use gloves and safety glasses when handling a steering wheel pad with deployed airbag.
-
Always wash your hands with water after completing the operation.
-
Do not apply water, etc.to a steering wheel pad with deployed airbag.
1. Remove the steering wheel pad from the steering wheel.
2. Place the steering wheel pad in a vinyl bag, tie the end tightly and dispose of it in the same way as other general parts disposal.
Airbag Assembly Connectors
DISCONNECTION
a. Place a finger on the slider.
b. Slide the slider to release lock.
c. Disconnect the connector.
CONNECTION
a. Align a lock part of male connector and a slider of female connector in the same direction as shown in the illustration, fit in them without rubbing.
b. Be sure to insert until they are locked. After fitting in pull them slightly to check that they are locked. (When locked, make sure that the outer
returns to its original position and sound at the time of fitting in can be heard.)
