Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
b. Using a hexagon wrench, install the 6 hexagon bolts and 3 joint washers.
Torque: 65 Nm (660 kgf-cm, 48 ft. lbs.)
36. INSTALL FRONT DRIVE FLANGE SHAFT SUB-ASSY
a. Pack the cross groove joint and side gear shaft with grease in the boot kit.
Grease capacity: 30 - 40 g (1.1 - 1.4 oz.)
b. Using a hexagon wrench, install the 6 hexagon bolts and 3 joint washers.
Torque: 65 Nm (660 kgf-cm, 48 ft. lbs.)
37. INSPECT FRONT DRIVE SHAFT ASSY LH
a. Check to see that there is no remarkable play in the OUTBOARD joint.
b. Check to see that the inboard joint slides smoothly in the thrust direction.
c. Check to see that there is no remarkable play in the radial direction of the inboard joint.
d. Check the boots for damage.
NOTICE: Move the drive shaft assy keeping it level.