Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
41. INSTALL FRONT SUSPENSION ARM SUB-ASSY
a. Install the lower ball joint to the lower suspension arm with the bolt and nut.
Torque: 127 Nm (1,300 kgf-cm, 94 ft. lbs.)
42. INSTALL TIE ROD ASSY LH
a. Install the tie rod end to the steering knuckle with the nut.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
b. Install a new cotter pin.
NOTICE: If the holes for the cotter pin are not aligned, tighten the nut further to 60°.
43. INSTALL SPEED SENSOR FRONT LH
a. Install the flexible hose to shock absorber with the bolt.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
b. Install the speed sensor to the steering knuckle with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE:
^
Be careful not to damage the speed sensor.
^
Prevent foreign matter from being attached.
^
Do not twist the sensor wire when installing the sensor.
44. INSTALL FRONT AXLE HUB LH NUT
a. Install the hub nut.
Torque: 294 Nm (3,000 kgf-cm, 217 ft. lbs.)