Landcruiser 4WD L6-4.5L (1FZ-FE) (1993)
(c)
Install a new gasket in position.
(d) Pour in approximately 15 cm3 (O.9 cu inch) of engine oil into oil pump hole.
(e)
Install the No. 1 oil pan with the 21 bolts and 2 nuts.
Torque:
14 mm head: 44 Nm (32 ft. lbs.)
12 mm head: 20 Nm (14 ft. lbs.)
9. Install No. 2 oil pan.
(a)
Remove any old packing FIPG material and be careful not to drop any oil on the contact surface of the No. 1 oil pan.
^
Using a razor blade and gasket scraper, remove all the old packing FIPG material from the gasket surfaces and sealing grooves.
^
Thoroughly clean all components to remove all the loose material.
^
Using a non-residue solvent, clean both sealing surfaces.
(b) Apply seal packing to the No. 2 oil pan as shown in the illustration.
CAUTION: Do not use a solvent which will affect the painted surfaces.
Seal packing: Part No. 08826 - 00080 or equivalent.
^
Install a nozzle that has been cut to a 2 - 3 mm (0.08 - 0.12 inch) opening or 3 - 4 mm (0.012 - 0.016 inch) opening.
NOTE: Avoid applying an excessive amount to the surface.
^
Parts must be assembled within 5 minutes of application. Otherwise the material must be removed and reapplied.
^
Immediately remove nozzle from the tube and reinstall cap.