Landcruiser 4WD L6-4.5L (1FZ-FE) (1993)
NOTE: Each bolt length is indicated in the illustration.
A: 30 mm (1.18 inch)
B: 50 mm (1.97 inch)
C: 60 mm (2.38 inch)
(f)
Remove the cord from the chain.
10. Install drive belt idler pulley.
Install the pulley with the bolt.
Torque: 43 Nm (32 ft. lbs.)
11. Install crankshaft pulley.
(a)
Align the pulley set key with the key groove of the pulley, and slide on the pulley.
(b) Using SST Crankshaft Pulley Holding Tool # 09213 - 58012, and Companion Flange Holding Tool # 09330 - 00021 or equivalents, install
and torque the pulley bolt.
Torque: 412 Nm (304 ft. lbs.)
12. Install No. 1 oil pan.
13. Install No. 2 oil pan.
14. Install bolts holding No. 1 oil pan to transmission housing.
Install the 6 bolts.
Torque: 72 Nm (53 ft. lbs.)
15. Install oil level sensor.
(a)
Install a new gasket to the level sensor.
(b) Install the level sensor with the 4 bolts.
Torque: 5.4 Nm (48 inch lbs.)
16. Connect oil cooler pipe bracket to No. 1 oil pan.
17. Install cylinder head.