Landcruiser 4WD L6-4.5L (1FZ-FE) (1993)
Fluid - A/T: Testing and Inspection
1. CHECK FLUID LEVEL
HINT: The vehicle must have driven so that the engine and transmission are at normal operating temperature. (Fluid temperature: 70 - 80°C or 158 -
176°F) Only use the COOL range on the dipstick as a rough reference when the fluid is replaced or the engine does not run.
(a) Park the vehicle on a level surface, set the parking brake.
(b) With the engine idling, shift the shift lever into all positions from P to L position and return to P position.
(c) Pull out the transmission dipstick and wipe it clean.
(d) Push it back fully into the tube.
(e) Pull it out and check that the fluid level is on the HOT range.
If the level is at the low side, add fluid.
Fluid type: ATF DEXRON-II
NOTICE: Do not overfill.
2. CHECK FLUID CONDITION
If the fluid smells burnt or is black, replace it in the following procedure.
(a) Remove the drain plug and drain the fluid.
(b) Reinstall the drain plug securely.
Torque: 280 kg.cm. (20 ft.lb., 27 N.m.)
(c) With the engine OFF, add new fluid through the oil filler tube.
Fluid type: ATF DEXRON-II