Landcruiser 4WD L6-4.5L (1FZ-FE) (1993)
/Page-898007.png)
2. INSTALL OIL SEAL SET END RETAINER
Install the parts in the following order:
(a) Felt dust seal
(b) Rubber seal
(c) Steel ring
3. PACK BEARINGS WITH MOLYBDENUM DISULPHIDE LITHIUM BASE GREASE
(a) Place molybdenum disulphide lithium base grease in the palm of your hand.
(b) Pack grease into the bearing, continuing until the grease oozes out from the other side.
(c) Do the same around the bearing circumference.
4. INSTALL STEERING KNUCKLE AND BEARINGS
(a) Place the bearings in positions on the knuckle and axle housing.
(b) Insert the knuckle on the axle housing.
5. INSTALL KNUCKLE ARM AND BEARING CAP
(a) Using SST, support the upper bearing inner race.
SST 09606-60020
HINT: Use SST with a collar.
(b) Install the bearing cap or the third arm over the shims that were originally used or were selected as described in the adjustment operations.
(c) Using a hammer, tap the bearing cap or the third arm into the bearing inner race.
