Matrix L4-1.8L (1ZZ-FE) (2008)
(a) Disconnect the skid control sensor wire connector from the skid control sensor.
6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle
Hub/Removal)
7. REMOVE SKID CONTROL SENSOR
(a) Mount the rear axle hub in a soft jaw vise.
NOTE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.
(b) Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
(c) Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.
SST: 09520-00031
09520-00040
SST: 09521-00020
SST: 09950-00020
NOTICE:
-
If a damage is inflicted to the sensor rotor, replace the axle hub assembly.
-
Do not scratch the contacting surface of axle hub and speed sensor.
Installation
BRAKE CONTROL: SKID CONTROL SENSOR:
COMPONENTS