Matrix L4-1.8L (1ZZ-FE) (2008)
(a) Using SST, hold the crankshaft.
SST: 09960-10010
09962-01000
09963-01000
(b) Remove the 8 bolts and flywheel.
6. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)
(a) Using SST, hold the crankshaft.
SST: 09960-10010
09962-01000
09963-01000
(b) Remove the 8 bolts and drive plate & ring gear.
7. REMOVE ENGINE REAR OIL SEAL
(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver with its tip wrapped with tape, pry out the oil seal.
NOTE: After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.