Matrix L4-1.8L (1ZZ-FE) (2008)
(b) Disconnect the ECM main wire connector from the CAN junction connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPLACE JUNCTION CONNECTOR
OK -- Continue to next step.
8. CHECK FOR SHORT IN CAN BUS WIRES (CAN JUNCTION CONNECTOR - ECM)
(a) Reconnect the ECM main wire connector to CAN junction connector.
(b) Disconnect the ECM connector (E5).
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance: